Nortel Networks 311 사용자 설명서
Physical description
863
The DTI/PRI card uses a 9.5" by 12.5" multilayer printed circuit board
with buried power and ground layers. The clock controller and D-channel
daughterboards are fastened by standoffs and connectors. See
with buried power and ground layers. The clock controller and D-channel
daughterboards are fastened by standoffs and connectors. See
.
The NTAK09 DTI/PRI card has seven faceplate LEDs. The first five LEDs
are associated with the NTAK09 card. The remaining two LEDs are
associated with the clock controller and DCHI daughterboards.
are associated with the NTAK09 card. The remaining two LEDs are
associated with the clock controller and DCHI daughterboards.
The first five LEDs operate as follows:
•
During system power up, the LEDs are on.
•
When the self-test is in progress, the LEDs flash three times and then
go into their appropriate states, as shown in
go into their appropriate states, as shown in
Figure 277
NTAK09 DTI/PRI circuit card
NTAK09 DTI/PRI circuit card
Table 352
NTAK09 LED states
NTAK09 LED states
LED
State
Definition
On (Red)
The NTAK09 circuit card is disabled.
DIS
Off
The NTAK09 is not in a disabled state.
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311
01.04
Standard
Release 5.0
23 May 2008
Copyright © 2003-2008, Nortel Networks
.