Multitech mt9234zba-usb 사용자 설명서
Appendix D – Installing with Linux
44
Multi‐Tech Systems, Inc. MT9234ZBA‐USB User Guide
Building and Installing the TI USB Driver from the TGZ Package
Follow this step if your distribution does not support RPM packages; otherwise, follow the previous step on
installing from an RPM package.
installing from an RPM package.
You need the TI USB 3410/5052 tgz package for this step. The Introduction section above describes where to find
the latest TI USB 3410/5052 tgz package.
the latest TI USB 3410/5052 tgz package.
Log in as root and do the following:
Command
Explanation
1. tar xvzf ti_usb_2.6‐X.Y.tgz
Un‐package the files.
2. cd ti_usb_2.6‐X.Y
3. ./configure
Configure the package for your distribution
and kernel.
and kernel.
4. make install
Build and install the ti_usb_3410_5052 driver.
If there are problems, you may need to go back to install and prepare the kernel sources as described above.
Loading the TI USB 3410/5052 Driver
The ti_usb_3410_5052 driver should be automatically loaded when you plug in the TI USB 3410/5052 devices,
provided your device uses the default vendor and product ids. If it does not, see the section of the Release Notes
file "VENDOR and PRODUCT IDS".
provided your device uses the default vendor and product ids. If it does not, see the section of the Release Notes
file "VENDOR and PRODUCT IDS".
The first TI USB 3410/5052 device plugged in appears as /dev/ttyUSB0, then next as /dev/ttyUSB1, and so on.
These device names are shared with other USB serial devices.
These device names are shared with other USB serial devices.
If TI USB devices had been in use before installing the new TI USB driver, old versions of the drivers can still be
loaded. You must unload these old versions before the newly installed driver is used.
loaded. You must unload these old versions before the newly installed driver is used.
To unload old drivers and load new driver:
1.
Reboot
or
2.
Close all open TI USB serial ports.
3.
Disconnect the TI USB serial devices.
4.
Unload the old TI USB serial driver with the command
rmmod ti_usb_3410_5052
5.
Reconnect the TI USB serial devices and the new driver is loaded.
Uninstalling the TI USB Driver (for 2.6 kernel versions)
If you installed the TI USB RPM package, you can uninstall it by logging in as root and running the command
rpm ‐e ti_usb_2.6‐X.Y‐Z
If you installed the TI USB TGZ package, you can uninstall it by logging in as root and using these commands:
Command
Explanation
cd ti_usb_2.6‐X.Y
Provide a full or relative path to the unpacked
source file directory.
source file directory.
make uninstall