Acer 08P4100 사용자 설명서
Installing the Mylex Disk Array Controller as the Primary NetWare 5.0 Controller
2-8
PCI Disk Array Controller Drivers Manual
☛
Note
In order to enable the CD-ROM boot, the controller’s
BIOS must be enabled.
BIOS must be enabled.
4. If the controller’s BIOS is disabled, press <Enter> to enable the BIOS.
5. Use the arrow key to select “CD-ROM boot disabled” and press
<Enter> to enable the CD-ROM boot.
6. Press <ESC>, then press any key. This will restart the system with the
new settings.
The system will now boot from the NetWare 5.0 CD-ROM.
7. Return to the section “Installing NetWare 5.0 Drivers” and follow steps
4 through 7 to complete your driver installation.
Installing Peripherals Under NetWare 5.0
Non-disk peripheral devices, such as tape or CD-ROM drives, can be
installed on any channel of the controller. Each disk or non-disk device will
require a unique SCSI ID, different from any other device connected to the
channel.
installed on any channel of the controller. Each disk or non-disk device will
require a unique SCSI ID, different from any other device connected to the
channel.
Each device requires a driver module connecting it to the DAC adapter.
These modules are best loaded in the STARTUP.NCF file before the
MDAC.HAM driver.
These modules are best loaded in the STARTUP.NCF file before the
MDAC.HAM driver.
The common devices and required modules are:
SCSI disk drives
SCSIHD.CDM
(including Mylex
RAID system drives)
RAID system drives)
SCSI CD-ROM
SCSICD.CDM
SCSI tape drive
NWTAPE.CDM
Magneto optical drive
SCSIMO.CDM
DLT tape drive
DLTTAPE.CDM
IDE CD-ROM
IDECD.CDM
IDE disk drive
IDEHD.CDM
ASPI compliant
NWASPI.CDM
applications such
as GAM
as GAM