AirLink 5200 사용자 설명서

AirLink Application Notes 

 

AirLink Communications 

              Page

 11

 

www.airlink.com

 

 

The following are the proper S-Register configurations for the AirLink Raven CDPD Modem when 

connecting to the IP5200 for making a PPP connection. These settings can be made using Wireless ACE. 
 

 
CDPD Parameters: 
[S110] Device Port=12345 
[\N]   Side Preference=3 
[S116] Service ID Preference=3 
[S111] Service ID=0/0/0 
[S112] Channel List Mode=2  
[S113] Channel List=0,0,0,0,0 
[3W] 3 Watt Booster Support=0 
[*DSIDE] Disable Side Switch=0 
[*CTSE] CTS CDPD Enable=0 
[#X] Serial Debug Output=0 
 

 
Connection Parameters: 
[S0]   TCP Auto Answer Mode=0 
[S7]   TCP Establishment Timeout=20 
[S50]  Data Forwarding Timeout=1 
[S51]  Data Forwarding Character=0 
[S53]  Destination IP Address=10.0.10.0 
[S53]  Destination TCP/UDP Port=12345 
[S53]  Destination Connect Mode=T 
[S210] AT Command Compatibility=1 
[S211] Ignore DTR=0 
[MD] Startup Mode Default=0 
[MD] UDP Mode Default=0 
[S60] Telnet Echo Mode=0 
[S82] UDP Half Open Mode=0 
[S83] UDP Half Open Timeout=5 
[AIP] Allow Any UDP IP=1 
[HOR] UDP Half Open Response=1 
[S220] Break On TCP Connect=0 
[S221] Delay Connect Response=0 
[E] Command Echo=1 
[V] Command Response Mode=1 
[Q] Quiet Mode=0 
[X] Call Progress Result Mode=0 
[TCPT] TCP Inactive Timeout=1 
[TCPS] Specify TCPT in Seconds=0 
[TCPX] Allow TCP Suspension=0 
[*DATZ] Disable Reset on ATZ=0 
[*ENQ] Enable ENQ on TCP Connect=0 
[DAE] Disable AT Esc Sequence=0 
[RKEY] Radio Transceiver Keying=0 
[IPL] IP List Dial=0 
[*DU] Dial UDP Always=0  
 

 
COM Port Parameters: 
[\Q] Flow Control=2 
[S23] Baud Rate=19200 
[S23] Data Bits=8 
[S23] Parity=N 
[S23] Stop Bits=1