Linksys AG241 사용자 설명서

8

Chapter 3: Getting to Know the ADSL2 Gateway with 4-

Port Switch

The Gateway’s ports, where a network cable is connected, are located on the back panel. The Gateway’s buttons 
are also located on the back panel.

The LINE port connects to the ADSL line.

The Ethernet ports connect to your computer and other network devices.

There are two ways to Reset the Gateway's factory defaults. Either press the Reset Button, for 
approximately ten seconds, or restore the defaults from the Factory Defaults screen of the 
Administration tab in the Gateway’s Web-Based Utility.

The Power port is where you will connect the power adapter.

This switch is used to turn the Gateway on or off.

With these, and many other, Linksys products, your networking options are limitless. Go to the Linksys 
international website at www.linksys.com/international for more information about products that work with the 
Gateway. 

Important: Resetting the Gateway to factory 

defaults will erase all of your settings 

and replace them with the factory defaults. Do 

not reset the Gateway if you want to retain 

these settings.