Enterasys Networks 2000 사용자 설명서

To attach the unit to AC power, simply plug the chassis into a grounded power source. For 
information about the AC power requirements, see Hardware Specifications

To attach the unit to the DC power supply, connect the ground, negative, and positive leads to their 
respective terminals at the rear of the unit. For information about the DC power requirements, see 
Hardware Specifications

.

: Before performing any upgrade or installation procedures, ensure that the 

XP-2000 is powered off and that you are properly “grounded” to avoid electrostatic discharge 
while working inside the XP-2000’s chassis.

A hardware restriction prevents the Xpedition 2000 from supporting configurations 
consisting of:

 

– Two (2) 1000Base-SX or 1000Base-LX Gigabit modules.

 

– Two (2) 100Base-FX modules.

 

However, the router does support a configuration consisting of one (1) Gigabit module and 
one (1) 100Base-FX module.

To install a 1000BASE-SX or 1000BASE-LX gigabit expansion module:

1.

Ensure that the XP-2000 is powered off.

2.

If your XP-2000 is equipped for rack mounting, use the phillips-head screwdriver to remove 
the mounting brackets from each side of the XP-2000.

3.

Take off the XP-2000’s top cover.

a.

Use the phillips-head screwdriver to remove the four mounting screws (two on each side 
of the router, front and back) that hold the top cover on the XP-2000.

8

7

6

5

4

3

2

1

8

7

6

5

4

3

2

1

CONSOLE

10/100 MGMT

OK

ERR

DIAG

HBT

RST

10/100BASE-TX

10/100BASE-TX

SYS

Enterasys Networks