Enterasys Networks 2000 사용자 설명서

9.

To display the active configuration, enter the system show active-config command, as shown 
in the following example:

Changes in the active configuration take effect on the running system but will not be restored 
following a reboot. 

10. To ensure that changes are restored following a reboot, you must save the active database to the 

Startup configuration file by taking the following steps:

a.

Enter the exit command to return to Enable mode.

b.

Enter the copy active to startup command.

The CLI displays the following message:

11. Enter yes or y to add the active configuration to the Startup configuration file.

You also can save active changes to the Startup configuration file from within Configure 
mode by entering the save startup command.

See Activating Configuration Changes and Saving the Configuration File

 for more 

information about the scratchpad, active database, and Startup configuration.

To use SNMP to manage the XP-2000, you need to set up an SNMP community on the XP-2000. 
Otherwise, the XP-2000’s SNMP agent runs in local trap process mode until you disable it using 
the snmp stop command. In addition, if you want to be able to access the SNMP traps issued by the 
XP-2000’s SNMP agent, you need to specify the IP address of the target for the SNMP traps.

To add the SNMP community string and specify the target for traps, take the following steps:

1.

Ensure that you are in Enable mode by entering the enable command in the CLI. 

2.

Ensure that you are in Configure mode by entering the configure command in the CLI. 

xp-1# system show active-config
Running system configuration:
     !
     ! Last modified from Console on Mon May 15 11:55:35 200
     !
 1 : system set name “xp-1”
 2 : system set location “Sunnyvale, CA”
 3 : system set contact “John Smith”

Are you sure you want to overwrite the Startup configuration [no]?