Enterasys Networks 1G58x-09 사용자 설명서
Port Configuration Command Set
Setting Speed and Duplex Mode
4-17
Example
This example shows how to display configured port duplex setting for front panel ports 10 through
16:
16:
4.3.3.4
set port duplex
Use this command to configure the duplex type of one or more ports. This setting only takes effect
on ports that have auto-negotiation disabled.
on ports that have auto-negotiation disabled.
You can use this command to configure the default duplex setting of a port while auto-negotiation
is enabled. However, the configured setting will not take effect until auto-negotiation is disabled.
is enabled. However, the configured setting will not take effect until auto-negotiation is disabled.
set port duplex port-string {full | half}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
E1-2>show port duplex fe.0.10-16
When autonegotiation is disabled,
the port duplex setting is:
port duplex
--------------------
fe.0.10 half
fe.0.11 half
fe.0.12 half
fe.0.13 half
fe.0.14 half
fe.0.15 half
fe.0.16 full
port-string
Specifies the port(s) for which duplex type will be set. For a
detailed description of possible port-string values, refer to
detailed description of possible port-string values, refer to
.
full | half
Sets the port to full-duplex or half-duplex operation.