Enterasys Networks 1G58x-09 사용자 설명서
Logging and Network Management Command Set
Managing Switch Network Addresses
11-38
11.2.3.5 set rad
Use this command to enable or disable RAD (Runtime Address Discovery) protocol. The Matrix
E1 uses BOOTP/DHCP to obtain an IP address if one hasn’t been configured. RAD can also be used
to retrieve a text configuration file from the network.
E1 uses BOOTP/DHCP to obtain an IP address if one hasn’t been configured. RAD can also be used
to retrieve a text configuration file from the network.
set rad {enable | disable}
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to disable RAD:
11.2.3.6 show mac
Use this command to display MAC addresses information in the switch’s routing table.
show mac [address mac address] [fid vlan_id] [port port-string] [type {learned
| self | mgmt}]
| self | mgmt}]
NOTE: In order for RAD to retrieve a text configuration file, the file must be specified in
the BootP tab.
the BootP tab.
enable | disable
Enables or disables RAD.
Matrix>set rad disable