TP-LINK TL-SG3210 사용자 설명서

 

155

 

Interface Configuration Mode (interface gigabitEthernet / interface range 

gigabitEthernet) 

Enable the STP function of port 1, and configure the Port Priority as 64, ExtPath 

Cost as 100, IntPath Cost as 100, and then enable Edge Port: 

TL-SG3424(config)# interface gigabitEthernet 1/0/1 

TL-SG3424(config-if)# spanning-tree common-config port-priority 64 

ext-cost 100 int-cost 100 portfast enable point-to-point open 

The spanning-tree mode command is used to configure the STP mode of the 

switch. To return to the default configurations, please use no spanning-tree 

mode command. 

spanning-tree mode { stp | rstp | mstp } 

no spanning-tree mode 

stp  ——Spanning Tree Protocol, the default value. 

rstp  ——Rapid Spanning Tree Protocol 

mstp  ——Multiple Spanning Tree Protocol 

Global Configuration Mode 

Configure the spanning-tree mode as mstp: 

TL-SG3424(config)# spanning-tree mode mstp 

The  spanning-tree mst configuration command is used to access MST 

Configuration Mode from Global Configuration Mode, as to configure the 

VLAN-Instance mapping, region name and revision level. To return to the