TP-LINK TL-SG3210 사용자 설명서

 

36

 

no gvrp timer [ leaveall | join | leave ] 

leaveall | join | leave —— They are the three timers: leave All、join and leave. 

Once the LeaveAll Timer is set, the port with GVRP enabled can send a 

LeaveAll message after the timer times out, so that other GARP ports can 

re-register all the attribute information. After that, the LeaveAll timer will start to 

begin a new cycle. To guarantee the transmission of the Join messages, a 

GARP port sends each Join message two times. The Join Timer is used to 

define the interval between the two sending operations of each Join message. 

Once the Leave Timer is set, the GARP port receiving a Leave message will 

start its Leave timer, and unregister the attribute information if it does not receive 

a Join message again before the timer times out.   

value ——The value of the timer. The LeaveAll Timer ranges from 1000 to 

30000 centiseconds and the default value is 1000. The Join Timer ranges from 

20 to 1000 centiseconds and the default value is 20. The Leave Timer ranges 

from 60 to 3000 centiseconds and the default value is 60. 

Interface Configuration Mode (interface gigabitEthernet / interface range 

gigabitEthernet) 

Set the GARP leaveall timer of port 6 to 2000 centiseconds and restore to the 

join timer of it to the default value: 

TL-SG3424(config)# interface gigabitEthernet 1/0/6 

TL-SG3424(config-if)# gvrp timer leaveall 2000 

TL-SG3424(config-if)# no gvrp timer join 

The show gvrp global command is used to display the global GVRP status.   

Privileged EXEC Mode and Any Configuration Mode