AudioSource In-Ceiling Speaker System 사용자 설명서

3

Tighten all four of the mounting screws in the same 

manner until the speaker is properly aligned and held 

tight to the wall surface. Caution: Do not over tighten!

A paint shields is included in each AC6CD speaker 

package. Place the paint shield inside the frame to 

protect the speaker. You can now safely paint the 

speaker’s frame to match your wall surface if you desire.

When painting the grill caution should be taken to 

ensure that paint does not clog or congest the perforated 

openings in the grill. This would prevent proper operation 

of the grill by restricting the airflow from the individual 

drivers in the speaker.

The AC6CD speaker is designed for use where the user 

desires to have sound available in an area but does not 

need stereo imaging. This may be because of limited 

space, such as a bathroom or dressing area, or a long 

hallway where even distribution of sound is desired but 

stereo imaging is impractical.

The AC6CD uses a dual voice coil woofer and dual tweet-

ers. The speaker has separate terminals to allow each 

channel of a stereo amplifier to be connected to the one 

speaker.

The AC6CD can also be operated by a single channel from 

an amplifier and used just like any conventional in-ceiling 

or in-wall speaker. In this configuration you should wire

the speaker terminals in parallel (fig. 4).

Should it ever become necessary to remove the AC6CD 

speaker from the ceiling, simply remove the grill and turn 

the four mounting screws counter-clockwise until you 

feel the doglegs lock out of position in their resting 

flange. The speaker should easily come out of the wall 

for service or replacement.

The resistance of the speaker wire in your installation 

can cause your speakers to perform at less than their 

optimum quality level. Excess resistance caused by 

using an undersized speaker wire can result in loss of 

detail and definition in the bass region of your audio 

program, as well as, a loss of dynamic range. Over 

extremely long wire runs you may even experience a 

loss of high frequency amplitude in the audio signal.

To prevent this effect in your installation we have 

recommended speaker wire gauges that should not 

exceed 0.5 ohms resistance over the recommended 

length of wire run.

For the AC6CD speakers we suggest the following 

minimum speaker wire gauge be used:

Figure 4

(+) Amp

(-) Amp

AC6CD

6.5” Two Way 

Dual Mono In-Ceilling

100W