Epson PM 290 사용자 설명서

●

Make sure your paper isn’t damp or curled, or 
loaded face down (load it glossy or whiter side 
up). If it’s damp or curled, load a new stack of 
paper.

●

Remove each photo from the output tray after 
printing. Let each photo sit for a minute before 
handling it.

●

The print head may need cleaning. See page 60. 

●

The photo cartridge may be old or low. See 
page 49 to replace it. 

●

Make sure your paper isn’t damaged, old, dirty, or 
loaded face down. If it is, load new paper with the 
glossy or whiter side up.

●

Make sure the Color Effect setting is not set to 
Black & White or Sepia. See page 22. 

●

The print head may need cleaning. See page 60. 

●

The photo cartridge may be old or low. See 
page 49 to replace it.

●

Colors may change slightly after your print dries. 
Wait for 24 hours and check your photo again.

●

Turn on the Enhance or P.I.M. setting. See 
page 19.

●

Try manually adjusting the brightness, saturation, 
or sharpness. See page 20. 

The paper may be damp. Load new paper.

●

If paper doesn’t feed, remove it, separate the 
sheets slightly, and reload it between the edge 
guides. Slide the guides to the edge of the paper, 
but don’t make them too tight. See page 6.

●

If multiple pages feed at once, remove the paper, 
separate the sheets, and carefully reload it.

●

If paper jams, remove any sheets loaded behind 
the jammed paper and press OK to eject the 
jammed paper. Don’t pull out jammed paper from 
the top of PictureMate.

●

Make sure the handle is not resting on the paper.