Lexmark 630 사용자 설명서
74
Using and loading the optional 2000-sheet drawer
Changing the print media size for the 2000-sheet drawer
Your 2000-sheet drawer comes pre-configured for either letter or A4 size.
of the following instructions
now. If you are changing the print media size for a unit that is already attached to a printer and a
power source, proceed with
power source, proceed with
:
1
Open the loading door.
2
Push the elevator button located on the left side of the door opening. See the illustration on
.
3
Remove paper from the elevator tray and close the loading door.
4
Re-open the door. The printer elevator tray should be approximately halfway up.
5
Unplug the power cord.
6
Remove the printer and all attached options from the 2000-sheet drawer.
CAUTION:
Remove the attached options one at a time. Make sure your fingers are not under
the printer when you set it down. Use the handholds on the printer or ask someone
to help you lift it.
the printer when you set it down. Use the handholds on the printer or ask someone
to help you lift it.
7
Locate the size selector knob on top of the drawer. See
for an illustration and
location of the knob.
Note: Six paper selections are available. Each paper selection is color-coded. A new print
media size is displayed on the operator panel after the paper elevator tray is in the
up position.
up position.
8
To make a selection, turn the knob completely in a counterclockwise direction. This action
sets the print media size to legal (LGL).
sets the print media size to legal (LGL).