Zebra Technologies 105S 사용자 설명서
Zebra S-Series User’s Guide
27
02'(.H\
The MODE key puts the printer in configuration mode. In this mode, you
can adjust the print darkness, media tear-off position, and label top
position, or perform a calibration. See “Configuration and Calibration”
beginning on page 39 for more information.
can adjust the print darkness, media tear-off position, and label top
position, or perform a calibration. See “Configuration and Calibration”
beginning on page 39 for more information.
)URQW3DQHO/LJKWV
Refer to Figure 11 for the location of the lights.
Note: If an operating condition which causes a light to be ON
constantly and one which causes the same light to flash occur
simultaneously, the light flashes.
simultaneously, the light flashes.
Indicator Light Name
Status
Indication
POWER
ON
Printer is on.
PRINTHEAD
OFF
Normal operation
ON
Head Over Temperature condition. Printing stops until the
printhead cools down. Printing resumes automatically.
printhead cools down. Printing resumes automatically.
Printhead Under Temperature condition. Printing
continues.
continues.
Power Supply Over Temperature condition. Printing stops
until the power supply cools down. Printing resumes
automatically.
until the power supply cools down. Printing resumes
automatically.
Flashing
Printhead Open.
PAPER/RIBBON
OFF
Media and ribbon (if used) are properly loaded.
ON
Paper out.
Flashing
1. In Thermal Transfer Mode: Ribbon is out.
2. In Direct Thermal Mode: Ribbon is in the printer.
PAUSE
OFF
Normal operation.
ON
Printer has stopped all printing operations.
DATA
OFF
Normal operation.
ON
Labels are printing.
Single Flash
The CANCEL key was pressed and a format was
successfully deleted from the print queue.
successfully deleted from the print queue.
Flashing
Receiving data from host computer.
Slow Flashing
Printer sent a “stop transmitting” command to the host
computer.
computer.
DARKEN
ON
Printer is in the Configuration Mode. See page 42 for
more information.
more information.
POSITION
ON
CALIBRATE
ON