TP-LINK TL-SL1351 사용자 설명서

 

4 

The front panel of the TL-SL1351 consists of a SFP module, which support The 
Hot Plug- And- Draw. Should fixed the SFP into SFP pluggable when use the SFP 
module. The switch could identify and configure the SFP module automatically. 

TL-SL1210/TL-SL1117/TL-SL1226/TL-SL1351 Gigabit Switch is powered by AC 
power supply. Powering on the Switch, it will automatically initialize and its LED 
indicators should respond as follows: 

1)  All of the LED indicators will flash momentarily for one second, which 

represents a resetting of the system. 

2)  The power LED indicator will remain ON. 

This Chapter describes the front panel, rear panel and LED indicators of the 
Switch (here takes TL-SL1351 for example). 

The front panel of TL-SL1351 consists of switch LED indicators, 48 10/100Mbps 
RJ-45 ports, 2 10/100/1000Mbps RJ-45 ports and 1 SFP module.   

The SFP module is only for TL-SL3151. 

 

Figure 3-1 TL-SL1351 Switch Front Panel sketch 

The LED indicators include Power, Link/Act, 1000Mbps and 100Mbps LED 
indicators, which are used for monitoring and pre-troubleshooting of the Switch. 
The following section explains the status of LED indicators for the Switch along 
with an explanation of each indicator. 

¾

  Power LED: This indicator will light solid red when the Switch powers up. If 

the LED is not lit, please check the power supply and connection.