Fujitsu RX330 사용자 설명서

RX330 S1

Operating manual

39

Hardware installation

For installation in a PRIMECENTER/DataCenter Rack, the following parts are 
required:

–

Support bracket

–

One left and one right telescopic rail (assembled) 

–

M5x10 screws with integrated plugwashers

I

–

Or, M5x10 screws with separate plugwashers can also be used. In 
this case, two plugwashers each must be fitted beforehand on the 
support uprights and the support bracket.

–

The descriptions and figures in this section refer to the current 
variable support.

–

General information is provided in the Technical Manual for the 
PRIMECENTER and/or DataCenter Rack (see 

When mounting the left telescopic rail in the PRIMECENTER/DataCenter Rack, 
the supplied support bracket must first be mounted on the rear left support 
upright flush with the bottom edge of the device.

Figure 3: Fitting the support bracket

Ê

Position the support bracket at the corresponding height on the rear left 
support upright, (insert lug in corresponding hole) (1).

Ê

Secure the bracket with two screws incl. plug washers (2).

2

1