Fujitsu TX200 사용자 설명서
202
Chapter 7 Installing Hardware Options
To make it easier to connect the server control cable into the server control port, apply pressure from
the cable side to the port side.
To use the remote service board, ServerView is required. Be sure to install it. For how to install
ServerView, refer to "6.2 Server Monitoring Tool [ServerView]" (
pg.170). For the remote service
board functions, refer to "ServerView User’s Guide."
When the remote service board is connected, the monitor brightness may become lower. In this case,
adjust the monitor for higher brightness.
The recommended screen refresh rate for the monitor is 70Hz. In case of poor resolution of the
monitor display, set the screen refresh rate to 70Hz.
7.5.3 How to Install an Expansion Card
1
Turn off the server and connected devices, and unplug all power cables from
the outlet.
2
Remove the side cover.
3
Touch a metal part of the server to discharge static electricity.
4
Push the slide lock to the left and remove the slot cover.
When installing a card in Slot 5, remove the PCI board.
Be sure to keep the removed slot cover or dummy cards for later use.
If operating the server with no expansion card, attach the slot cover to keep dust away.
If operating the server with no expansion card, attach the slot cover to keep dust away.
PCI board
Slide lock