Fujitsu TX200 사용자 설명서

Chapter 2 Checking before OS Installation

2.1 Preparation on the Server

Before starting installation, install internal options to the server and perform

necessary hardware settings.

2.1.1 Installing Internal Options

Internal options are classified into those that must be installed before the OS installation and those that

must be installed after the OS installation.

●

Internal Options That Must be Installed before the OS installation

• Memory modules

• CPUs

• Expansion cards

●

Internal Options That Must be Installed after the OS installation

• Optional SCSI devices

• Internal hard disk units where the Operation System is not installed

If an internal option device that must be installed after the OS installation has been already installed,

remove the device, install the OS, then reinstall the device.

■ Cautions for Installing an Expansion Card

When using an expansion card, read the notes on the expansion card.

■ Cautions for Installing an Optional SCSI Device

When adding an optional SCSI device (DAT, etc.) using a SCSI card, connect it after installing the OS.

Connecting it before OS installation may result in improper drive letter assignment.

■ Cautions for Installing a Memory Module

This server supports up to 6GB of memory. However, the maximum installable size varies depending on

the OS. Furthermore, since the server uses part of the memory as PCI resources, the maximum available

size is limited. The following shows the maximum installable size and the maximum available size.

table: Maximum Installable Size and Maximum Available Size

Installed memory

size

Available memory size

Windows 2000 Server

Windows Server 2003, Standard

Edition

3.0GB or smaller

Same as the installed memory size

3.5 to 4.0GB

Installed memory size - (0.1 to 0.6GB)