Fujitsu TX150 S3 사용자 설명서

U41604-Z156-1-76

Options Guide

29

Accessible drives

In the SCSI version the two lower 5.25 inch bays for accessible drives can be 
used to install a HDD extension box. But it is required that the server is equipped 
with a 1- or 2-channel RAID controller.

I

It is not allowed to operate the hard disks of the HDD extension box 
together with the internal hard disks via one common SCSI line.

If the server has a RAID controller and a corresponding RAID configuration, 
defective hard disk modules can also be exchanged during operation.

Ê

Open the server and remove the front cover or rack front cover as described 
in the chapter “Preparation” on page 13 et seqq. .

I

The hard disks extension box is supplied without EasyClick rails. You 
need 8 M3 screws. Before installing a new hard disks extension box you 
must therefore remove the EasyClick rails from the two dummy covers 
and mount two of the four EasyClick rails on the hard disks extension 
box.

Ê

Remove the dummy covers from the two lower 5.25-inch bays for accessible 
drives:

Ê

Press the two metal tongues of the EasyClick rails inward (1) until the 
locking mechanism is released.

Ê

Remove the dummy cover from the bay.

Ê

Remove the EasyClick rails from the two dummy covers by removing the four 
screws on each side.

I

Note that there are two M3 screws and two UNC screws on each side.

V

Keep the dummy covers for future use. If you remove the hard disks 
extension box again and do not replace it with new drives, the dummy 
covers must be reinstalled to comply with EMC regulations and to 
satisfy cooling requirements and fire protection measures.