Fujitsu N800 사용자 설명서

U41243-J-Z156-1-76

 29

Installing the server

Ê

Connect the data cables to the devices and the server.

I

Some of the connected devices require that you install and configure 
special software (e.g. drivers) (see the documentation for the connected 
device).

If you are using a separate graphics card in a slot, the graphics controller on the 
system board is automatically deactivated. The corresponding monitor port 
(SVGA) cannot be used. Instead, connect the data cable of the monitor to the 
monitor port of the graphics card.

Several servers and storage subsystem (e.g. PRIMERGY S40-DF) can be 
combined to form a group (functional unit, family/cluster). All the devices in a 
group are assigned the same group ID but different device IDs. This ID (CAN 
bus address) can be used to address each device using the communications 
bus (CAN bus). A maximum of ten groups can be set up on one communica-
tions bus. All the devices in a group must be connected to the same CAN bus.

The CAN bus is a cable connection. The CAN bus must be terminated, i.e. 
terminating resisters must be attached to free ends.

The server includes a PCI CAN bus controller (figure 11 on page 30), which 
enables communication with a PRIMERGY S40-DF in a cluster configuration.

Communication between the PCI CAN bus controller and the storage 
subsystems is enabled with the help of the ServerStart CD:

(

)