Fujitsu MX130 S2 사용자 설명서
MX130 S2
Upgrade and Maintenance Manual
191
Processors
Ê
Fasten the four captive screws on the heat sink (screw torque: 0.6 Nm, not
applicable for the Japanese market).
applicable for the Japanese market).
Ê
Connect the CPU fan cable to the system board connector FAN1.
11.2.6 Concluding steps
Perform the following procedures to complete the task:
Ê
Follow all procedures described in section
.
11.3
Replacing the processor
V
CAUTION!
Processors are extremely sensitive to electrostatic discharge and must
be handled with care. After a processor has been removed from its
protective sleeve or from its socket, place it upside down on a
nonconducting, antistatic surface. Never push a processor over a
surface.
be handled with care. After a processor has been removed from its
protective sleeve or from its socket, place it upside down on a
nonconducting, antistatic surface. Never push a processor over a
surface.
11.3.1 Required tools
●
Preliminary and concluding steps: tool-less
●
Removing and installing the processor heat sink:
– Phillips PH2 / (+) No. 2 screw driver
●
Removing and installing the processor: tool-less
Field Replaceable Units (FRU)
Average hardware task duration: 15 minutes
Average software task duration: 5 minutes