Fujitsu MX130 S2 사용자 설명서

64

Upgrade and Maintenance Manual

 MX130 

S2

In order to configure an expansion card that has been installed or replaced, the 
card’s Option ROM has to be enabled in the system board BIOS. The card’s 
firmware is called by the system BIOS upon reboot and can be entered and 
configured.

Option ROM can be enabled permanently (e.g. in case of a boot controller that 
may require frequent setup) or temporarily for one-time configuration.

When the enabled expansion card is initialized during the POST phase of the 
boot sequence, a key combination is displayed temporarily to enter the 
expansion card’s firmware.

Ê

Press the displayed key combination.

Ê

Modify the expansion card firmware options as desired.

Ê

Save your changes and exit the firmware.

As default setting for this system, Option ROM is enabled for all onboard 
controllers and all expansion card slots.

For detailed information on how to access the BIOS and modify settings, refer 
to the "D3090/D3091 BIOS Manual".

I

This task only applies to the Japanese market.

Depending on the backup software solution, it may be necessary to disable or 
delete the backup drive from the backup software drive list and reconfigure 
backup jobs after completing the maintenance task.

This is the case for the following backup software solutions:

– Netvault for Windows
– ARCServe
– BackupExec