Actron 9640A 사용자 설명서
Help & Troubleshooting
8 – 6 • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
If the scan tool experienced a problem in transmitting, check connections and
try again.
try again.
TRYING PRINT AGAIN sends print test information to the printer. Use this
selection if you find the cable is not properly installed, or the printer is not on or
on-Line. If any of the mentioned conditions were found, correct them and select
Print Again. A garbled or no print may be caused by the interface settings. You
can change the Scan Tool’s settings if necessary. See section “Printer Inter-
face” on page 3-4 of Using The Scan Tool.
selection if you find the cable is not properly installed, or the printer is not on or
on-Line. If any of the mentioned conditions were found, correct them and select
Print Again. A garbled or no print may be caused by the interface settings. You
can change the Scan Tool’s settings if necessary. See section “Printer Inter-
face” on page 3-4 of Using The Scan Tool.
PROGRAM MODE
The Program Mode is accessed from
the
the
Main Menu. This mode is used for
updating the Scan Tool software.
Instructions are provided with the new
software.
Instructions are provided with the new
software.
TECHNICAL SUPPORT
• Toll-Free Number: 1-800-228-7667
• e-mail: tech_support@actron.com.
• e-mail: tech_support@actron.com.
---
[
Print Test
]
---
!"#$%'()*+,-./
0123456789:;<=>?@ABCDEFGHIJKLMNO
PQRSTUVWXYZ[\]^_'abcdefghijklmno
pqrstuvwxyz{|}~
Main Menu
|
Tool Setup
]
Tool Self-Test
` Program Mode
~