Wacom CTL470 사용자 설명서
56
56
WIRELESS SETUP
Configure Bamboo for wireless operation.
1. If you have been using Bamboo as a wired tablet, disconnect the USB cable.
2. Turn the tablet over. Remove the wireless compartment cover(s). See (A).
Slide cover(s) away from tablet body to remove. Tablet model CTH-670 is
equipped with two covers: one for the Wacom wireless module, and one for
the rechargeable battery.
equipped with two covers: one for the Wacom wireless module, and one for
the rechargeable battery.
3. Install the wireless components.
4. If you have not already done so, turn on your computer and wait until the system has fully loaded.
Next, connect wirelessly.
A
•
Install the battery. Align contacts (B) as
shown and press into place. See also
shown and press into place. See also
.
•
Install the wireless module. Lift away and
remove the wireless module spacer (C). Slide
the wireless module into the tablet, ensuring
the connector is fully seated (D).
remove the wireless module spacer (C). Slide
the wireless module into the tablet, ensuring
the connector is fully seated (D).
Important: Save the module spacer. You
may need it as a tool for removal of the
wireless module, and to protect the tablet
interior from dust when the module is not
installed. See
may need it as a tool for removal of the
wireless module, and to protect the tablet
interior from dust when the module is not
installed. See
.
•
Replace the wireless compartment cover(s).
Align and slide into place (E).
Align and slide into place (E).
•
Connect the Wacom wireless receiver to an
active USB port on your computer or USB
hub (F).
active USB port on your computer or USB
hub (F).
.
B
C
D
E
F