Addonics Technologies ZBW-10LS2EU 사용자 설명서
Addonics
T E C H N O L O G I E S
Zebra Blu Ray & DVD±R/RW Writer
with eSATA and USB interface
ZBW-10LS2EU
User’s Guide
FCC Warning Statement
This equipment has been tested and found to comply with the limits for a class B digital
device pursuant to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy. If not installed and
used in accordance with the instructions, it may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If the equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment on and off, the user
is encouraged to try and correct the interference by one or more of the following
suggestions.
Reorient or relocate the receiving antenna
Increase the distance between the equipment and the receiver
Connect the equipment to a different power outlet other than the one where receiver is
connected
Consult a certified television or radio technician
This equipment has been tested and found to comply with the limits for a class B digital
device pursuant to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy. If not installed and
used in accordance with the instructions, it may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If the equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment on and off, the user
is encouraged to try and correct the interference by one or more of the following
suggestions.
Reorient or relocate the receiving antenna
Increase the distance between the equipment and the receiver
Connect the equipment to a different power outlet other than the one where receiver is
connected
Consult a certified television or radio technician
Enclosure Overview
Rear View
Hardware Installation
1. Connect the power adapter to the power connector located at the back of the
enclosure.
2. Connect the data cable using
a. eSATA connection
Note: You should have configured the eSATA host controller on your
system before you connect the writer. Once the eSATA host controller is
configured, do the following steps below.
Plug-in the eSATA cable to the eSATA port on the enclosure and
attached the other end to your eSATA host controller.
system before you connect the writer. Once the eSATA host controller is
configured, do the following steps below.
Plug-in the eSATA cable to the eSATA port on the enclosure and
attached the other end to your eSATA host controller.
b. Or USB2.0 connection
Attach the USB cable to the USB port on the enclosure and in your
system.
system.
Screw 2
Fan
Switch
USB Port
eSATA Port
Power
Connector
Connector
Power LED
Drive Activity LED
Eject Button
Screw 1