Mitsubishi Electronics A0567659 사용자 설명서
Gravimetric Batch Blenders w/Mitsubishi Control Chapter 4: Operation
56
Chapter 4: Operation
4-1 Start-up
General Operation
The general operation of the Slide Gate/Auger blending system is as follows: Once the
system is properly installed and set up, the system will be ready for operation. Please see the
Installation and Setup chapter in this manual for further information.
The general operation of the Slide Gate/Auger blending system is as follows: Once the
system is properly installed and set up, the system will be ready for operation. Please see the
Installation and Setup chapter in this manual for further information.
Once the Slide Gate/Auger blending system is powered on, the unit will display the recipe
screen (the recipe format should be in “Quickset” recipe mode). Pressing the highlighted box
next to the feeder number, the operator can enter a valid recipe or use a previously stored
recipe from the recipe book.
screen (the recipe format should be in “Quickset” recipe mode). Pressing the highlighted box
next to the feeder number, the operator can enter a valid recipe or use a previously stored
recipe from the recipe book.
1. The blender is started by turning system on or material dropping below level switch
in mix chamber.
2. Metering gates are opened (or auger motors are turned on) to meter material into the
weigh hopper in the programmed order.
3. Each component is weighed, then the batch is dumped into the mix chamber
(provided the mixer “High level” switch is not covered).
4. The material is mixed in the mix chamber and flows into the processing machine.
5. The optional slide gate below the mixer may control the flow of material to the
molding machine or extruder.
Quick Start Procedure
New Recipes
New Recipes
1. Calibrate the weigh hopper before running the blender (This will improve inventory
accuracy.). See page 45 for calibration instructions.
2. Ensure that all ingredient supply hoppers to be used are filled with material. Virgin
material should be loaded into hopper #1 and regrind into hopper #3.
Note: Hopper #3 is equipped with an oversized square gate to assist in the feeding of
the regrind material.
3. Enter the recipe menu on the LCD panel by turning on the PanelView controller (It
will automatically default to this screen), and enter the blend recipe desired following
the steps listed below:
the steps listed below:
• Touch the box (labeled 1-6) that shows the hopper you want to change.
• Touch the “Touch Here to CHANGE” button.
• Enter in the new value (0 to 999.99) and hit the enter button (arrow).
• Touch “Done”.
• After you have entered the new values for all hoppers (1-6), then push
• Touch the “Touch Here to CHANGE” button.
• Enter in the new value (0 to 999.99) and hit the enter button (arrow).
• Touch “Done”.
• After you have entered the new values for all hoppers (1-6), then push
the “Accept New Recipe” button and the recipe will be entered.