Globe SP30 사용자 설명서

Page 8

NOTE:  It is easier to install the agitator prior to adding the ingredients into the bowl.

1.  Rotate the bowl guard to the left so it rests in the open position (see fi g 8-1).

Excessive force used to open and close the bowl guard may damage the 
spring lock and bowl guard microswitch, and will void the warranty.

2.  Slide the agitator slowly upwards onto the planetary shaft fi tting the shaft pin through the  
 

slot in the agitator (see fi g 8-2). 

3.  Rotate the agitator clockwise to secure it onto the planetary shaft.

Follow the capacity chart located on page 13 in this manual.  
Overloading or not following this chart will damage the mixer and void 
the warranty.

Agitators should always rotate in a clockwise direction around the bowl.  If the agitator moves 
counterclockwise, contact a licensed electrician immediately to remedy 
incorrect wiring.

1.  Add the appropriate mixing ingredients into the bowl.

2.  Lift completely up on the bowl lift lever until the bowl locks into position.  On the  

 

 

SP40P and SP60P rotate the bowl lift wheel clockwise until the bowl is all the way  

 

 

up into position.  For the SP62P and SP80PL press the up arrow (blue button) until the 

 

bowl is up into position.

3.  Rotate the bowl guard to the right so it locks into the closed position (see fi g 8-3).  
 

A clicking sound will be heard.  

NOTE:  The mixer will not start if the bowl guard is open or the bowl is in the lowered position.

4.  Set the timer for the appropriate mixing time or set the mixer for non-timed operation.
 a.  Timed Operation:  Turn the timer knob in a clockwise direction at least fi ve minutes past “0” to the desired  
 

 

time.  NOTE:  To set the time for less than fi ve minutes turn the timer knob clockwise to six then    

 

 

 

counterclockwise back to the desired time. 

 b. 

Non-Timed Operation:  Turn the timer knob in a counterclockwise direction to the green “on” position.     

 

 

NOTE:  Heavy loads should not be mixed longer than fi fteen minutes at this setting without an equal  

 

 

 

amount of rest time.  Failure to adhere to these instructions may cause the mixer to automatically shut off   

  due 

to 

overloading.

Fig. 8-1

Fig. 8-2

Fig. 8-3