Zanussi ZFC 638 WAP 사용자 설명서

3

Do not remove the power supply cable by pulling on its lead, particularly when the freezer is being pulled out of its
niche.
The power supply cable may only be replaced by qualified service personnel.
Ensure that the power plug is not squashed or damaged by the back of the freezer.
There must be adequate ventilation around the appliance.
Any electrical work required to install this appliance should be carried out by a qualified electrician.

Warning! This appliance must be earthed.

The appliance is supplied with a 13amp plug fitted. In the event of having to change the
fuse in the plug supplied, a 13amp ASTA approved (BS1362) fuse must be used. Should
the plug need to be replaced for any reason. The wires in the power supply cable are
coloured in accordance with the following code:

Green and Yellow - Earth: must be connected to the terminal marked with the letter "E"
or by the earth symbol or coloured green and yellow.
Blue - Neutral: must be connected to the terminal "N" or coloured black.
Brown - Live: must be connected to the terminal marked "L" or coloured red.

Upon completion there must be no cut, or stray strands of wire present and the cord
clamp must be secure over the outer sheath. 

Warning! This appliance must be earthed.

Before first use, the freezer should be cleaned inside, see chapter "Care and cleaning".
Plug in the appliance.
The green light will come on.
The red light will also switch on to indicate that the temperature inside the freezer is not yet sufficiently low for food storage.
The red light will normally switch off after several hours.
Only place food inside the freezer once the red light has switched off.

Turn the thermostat knob to a postion between 

and 

. 

Turn the thermostat knob to the Off position.

To adjust the temperature of the freezer, proceed as follows:

Turn the thermostat knob clockwise towards  

for a colder storage temperature.

Turn the thermotat knob counter-clockwise towards 

for a less cold storage temperature.

If more than 3-4 kg of fresh food is to be frozen, the freezer needs to be pre-cooled.

At least 24 hours before placing fresh food in the freezer, press button (D).
The yellow light comes on.
Place the food in the freezer. This function can be de-activated any time by pressing button (D) again.

If the freezer temperature is not sufficiently low, the red light will come on.

The red light remains on as long as the temperature in the freezer is higher than the thermostat setting.

The alarm can be due to:

Insertion of a large amount of fresh food.
Opening the lid too long.
A defect in the system, see chapter "What to do if...".

Hang the baskets on the upper edge (X) or place the stackable baskets inside the freez-
er (Y).
Turn and fix the handles for these two positions, as shown in the drawings.