KitchenAid KHHC2090S 사용자 설명서

Tones are audible signals, indicating the following:

■

Valid entry (short tone)

■

Between stages (short tones)

■

Reminder, repeat each minute for 10 minutes after the end-
of-cycle tones

■

End of Timer countdown

■

Hidden feature entered or exited (very short, quick tones)

■

Invalid entry (very short, quick tones)

■

Retry Error

■

End of cycle (2 short tones, followed by 2 longer tones)

■

Interruption, tend to food (short tones)

■

Attention - door needs to be opened and closed

1. On Main Menu, touch “Settings & Info.”

2. On Settings & Info screen, touch “More Choices.”

3. Touch “Volume.”

4. Using “+” and “-” controls, increase or decrease the volume 

setting, or turn the tones off.

5. Touch “Ok.”

The START control will start any function.

If non-sensor cooking is interrupted, touching the START control 
pad will resume the preset cycle.

If the microwave oven has not been in use and the door has not 
been opened in the past 5 minutes, the cooking function will not 
start. Open and close the door, then touch START to start or 
resume the cooking cycle.

For added convenience, the “Start” touch pad is also available on 
some display screens, and provides the same function as the 
START control pad.

The OFF control stops all functions except for the Timer and 
Learning Mode, and cancels programming in progress.

The microwave oven will also turn off when the door is opened. 
Close the door and touch START control or “Continue” on the 
touch screen to resume the cycle. A sensor cooking cycle may 
not be resumed if interrupted by opening the door.

During programming, the CLEAR control changes the numeric 
programming values, such as minutes, seconds and cook power 
that are active in the display to their default value. For example, 
while entering a cook time, touching CLEAR will change the time 
you have already entered to “0:00.” The CLEAR control gives an 
invalid signal (see “Tones” section) if touched during cooking.

The Timer can be set in minutes and seconds, up to 99 minutes, 
and counts down the set time. 

NOTE: The Timer does not start or stop the microwave oven.

While the Timer is in use, the microwave oven can still operate. 
During a microwave oven operation, the Timer countdown will be 
minimized. If the Timer ends while microwave oven is still 
operating, the end-of-Timer tones will sound, and the set 
operating mode will remain active on the screen.

1. Touch TIMER control.

2. Using the number pads, enter desired time in minutes and 

seconds, and then touch “Start Timer.”

The countdown will be in full screen view. 

3. Touch “Ok” to minimize the timer. 

To see the countdown in full screen view, touch TIMER control.

The time can be reset during the countdown by touching TIMER, 
entering a new time, then touching “Ok,” or the START control.

To Cancel: Touch TIMER control, then touch “Cancel Timer.”

The Control Lock disables all controls to avoid unintended use of 
the microwave oven. The only control that will function while the 
Control Lock is active is the OFF pad on the control panel.

Control Lock activation is possible only when the display is at the 
Main Menu.

To Activate Control Lock: Touch and hold OFF control for 
5 seconds. Two tones will sound, and the display will show the 
padlock icon.

A