KitchenAid KHHC2090S 사용자 설명서

The cooktop light consists of two 10W low-voltage halogen 
capsule bulbs. See “Assistance or Service” section to reorder. 
You will need a TORX

®†

 T10 screwdriver to remove the bulb cover 

mounting screw.

1. Unplug microwave oven or disconnect power.

2. Remove bulb cover mounting screw, and gently open cover.

3. Remove the burned-out bulb.

4. Replace bulb, using a tissue or wearing clean cotton gloves 

to handle the bulb. Do not touch bulb with bare fingers.

5. Close bulb cover and replace mounting screw.

6. Plug in microwave oven or reconnect power.

The microwave oven light is a 10W low-voltage halogen capsule 
bulb. It will automatically come on when the door is opened and 
when the microwave oven is operating. See “Assistance or 
Service” section to reorder. You will need a TORX

®†

 T10

 

screwdriver to remove the bulb cover.

1. Unplug microwave oven or disconnect power.

2. Gently pull vent screen rings and lift the screen off the 

exhaust vent at the top of the microwave oven.

If using recirculating exhaust venting, skip Step 3.

3. For wall or roof venting, remove the vent deflector by 

removing the mounting screws (1 from each end), and lifting 
out the vent deflector.

4. Remove the bulb cover mounting screw, then lift cover.

5. Remove the burned-out bulb by squeezing the wire clip 

together, pulling to the right and lifting.

6. Replace bulb, using tissue or wearing clean cotton gloves to 

handle bulb. Do not touch bulb with bare fingers.

7. Close bulb cover, and fasten with screw.

If using recirculating exhaust venting, skip Step 8.

8. For wall or roof venting, replace the vent deflector removed in 

Step 3.

9. Replace vent screen.

10. Plug in microwave oven or reconnect power.

A        B         C

†®TORX is a registered trademark of Textron Innovations Inc.

A                              B                               C

A                     B                   C

A