Zanussi ZERC 3025 사용자 설명서

3

2

4

Before use 

4

Setting the temperature

4

Fresh food refrigeration 

4

Normal operating sounds

5

Movable shelves

5

Positioning the door shelves

5

6

6

Internal cleaning

6

External cleaning

6

When the appliance is not in use 

6

Changing the light bulb 

7

Defrosting

7

8

9

9

10

11

12

Positioning

12

Rear Spacers

12

13

14

14

1. Disconnect from the electricity supply.

2. Gently lay the fridge on its back with the top held

away from the floor by 5-8 cm (2-3 inches) of
packing;

3. Remove the ventilation grill (D).

4. remove the bottom hinge (E) by unscrewing its

three fixing screws;

5. Slide out the fridge door from pin (G), unscrew

the latter and then refit it on the opposite side;

6. remove the two plugs of the door (where

available), discovering the holes for the hinge
pins, assemble them on the opposite side;

7. reassemble the door;

8. using a 10 mm spanner, unscrew the hinge pin

(E) and reassemble it on the opposite side of the
hinge;

9. reassemble the lower hinge (E) on the opposite

side, using the screws previously removed. Slide
the hole cover (F) out of the ventilation grille (D)
by pushing it in the direction of the arrow and
reassemble it on the opposite side;

10.refit the ventilation grille (D), clipping it into place;

11. Unscrew the handle. Refit it on the opposite side

after having pierced the plugs with a punch.
Cover the holes left open with the plugs supplied
in the documentation pack.

After completion of the door reversing operation,
check that the door gasket adheres to the cabinet. If
the ambient temperature is cold (i.e. in Winter), the
gasket may not fit perfectly to the cabinet. In that
case, wait for the natural fitting of the gasket or
accelerate this process by heating up the part
involved with a normal hairdryer on a low setting.

F

F

D

F

F

E

E

Printed on recycled paper