Vinotemp VT48TEDS2Z 사용자 설명서

 

 

•  Remove any exterior and interior packing material. 

•  Check to be sure the following parts are included: 

♦ 

For 48-Bottle Wine Cellar, 14 slide out shelves, 7 for each 
side. 

♦ 

1 instruction manual. 

•  Before connecting the appliance to the power source, let it stand 

upright for approximately 2 hours. This will reduce the possibility 

of a malfunction in the cooling system from handling during 
transportation. 

•  Place your appliance on a floor that is strong enough to support 

the appliance when it is fully loaded. 

•  To level your appliance, adjust the front legs at the bottom of the 

appliance. 

•  For freestanding installation only, away from direct sunlight and 

sources of heat (stove, heater, radiator, etc.). Direct sunlight may 
affect the acrylic coating and heat sources may increase electrical 

consumption. 

•  Clean the interior surface with lukewarm water using a soft cloth. 

It is recommended that you install the wine cellar in a place where 
the ambient temperature is between 77-80.6°F. If the ambient 
temperature is above or below recommended temperature, the 

performance of the unit may be affected. Placing in extreme cold or 
hot conditions may cause interior temperature to fluctuate. The 

range of 54-66°F may not be reached. Not intended for garage or 
basement installs. The temperature may fluctuate depending on 

whether or not the interior light is on or off or whether the bottles are 
located on the upper/middle or lower section. Close the cooler door 

immediately after putting in any items so the inside temperature will 
not rise dramatically.