NorthStar 941x 사용자 설명서
Page 60
5 — Waypoint and Route Navigation
5 — Waypoint and Route Navigation
5 — Waypoint and Route Navigation
5 — Waypoint and Route Navigation
Rev. D
changes to a connecting arrow between the two waypoints, as in
screen #2 above. Press the GO menu key, then ENTER.
screen #2 above. Press the GO menu key, then ENTER.
To start following the route, select the waypoint or leg you want to start
on, press the GO menu key, then ENTER.
on, press the GO menu key, then ENTER.
Before you actually start the route, you can display planning information
about the route in the GO ALONG ROUTE screen. An estimate of the
time required to travel to the selected waypoint is displayed near the top.
As you scroll the pointer up or down, the ETA will change for each way-
point. This estimate is based on the Speed-Over-Ground figure displayed
at the bottom of the screen.
about the route in the GO ALONG ROUTE screen. An estimate of the
time required to travel to the selected waypoint is displayed near the top.
As you scroll the pointer up or down, the ETA will change for each way-
point. This estimate is based on the Speed-Over-Ground figure displayed
at the bottom of the screen.
To change this figure, press the USUAL SOG menu key and enter the
new value to be used in calculating the time. Use the cursor arrow keys
again to scroll through the Estimated Times of Arrival for different way-
points of the route.
new value to be used in calculating the time. Use the cursor arrow keys
again to scroll through the Estimated Times of Arrival for different way-
points of the route.
To access the USUAL SOG and waypoint ETA features from any screen,
proceed as though you were going to follow a route by pressing the
WAYPTS/ROUTES key, then ROUTE LIST, then select the route you
wish to view. Press GO to display the ETA of each waypoint in the route
and the USUAL SOG window at the bottom of the screen. To exit with-
out actually following the route, press any function key.
proceed as though you were going to follow a route by pressing the
WAYPTS/ROUTES key, then ROUTE LIST, then select the route you
wish to view. Press GO to display the ETA of each waypoint in the route
and the USUAL SOG window at the bottom of the screen. To exit with-
out actually following the route, press any function key.
planning ETA to
any waypoint
"