NorthStar 941x 작동 가이드

941/951x GPS Chart Navigators

Waypoint/Route Sharing & Color Palette Selection Operator Instructions, Rev. C

5 of 8

If there’s no problem with the transfer process, the master unit’s status bar displays the message
TRANSFER COMPLETE when done. You can now press any key to resume other operations.

Moving waypoints and routes from a master unit (export)

When you move waypoints from unit 1 (the designated master) into unit 2, the entire contents of unit
1 are exported into unit 2. Also, if any waypoint or route name matches exist, the waypoints or
routes from unit 1 will overwrite the waypoints or routes already in unit 2.

1. Select the unit you’d like to use as the “master.” Remember: You can use either of two units as

the master because both units are capable of importing or exporting waypoints and routes.

2. At the “master” unit, press the WAYPTS/ROUTES key to display the WAYPTS AND ROUTES

screen.

NOTE:

If you press any function key on the master unit during the
transfer, the error message

TRANSFER ABORTED BY KEY

HIT

will be displayed, the process will be aborted, and the

master unit will display the particular screen accessed by that
function keypress. You can press any key on the other unit,
however, without interrupting the transfer process.

To purposely stop the transfer at any time, press the

STOP

key. If you press the

STOP

key, the master unit displays the

dialog-box message

TRANSFER ABORTED BY KEY HIT

and the status bar displays the message

TRANSFER

ABORTED

. Waypoints and routes transferred up to that point

are in the receiving unit (be aware that a particular route may
not contain all of its waypoints due to the transfer interruption).
Press the

START

key again to re-start the entire transfer pro-

cess (this means that all waypoints and routes, not just the
ones already in the receiving unit and the ones left to be trans-
ferred, are re-transferred).