Lexmark i3 사용자 가이드

The Lexmark i3 has been tested and found to comply with the limits for a 
Class B digital device, pursuant to Part 15 of the FCC Rules. Operation is 
subject to the following two conditions: (1) this device may not cause harmful 
interference, and (2) this device must accept any interference received, 
including interference that may cause undesired operation.

The FCC Class B limits are designed to provide reasonable protection against 
harmful interference in a residential installation. This equipment generates, 
uses and can radiate radio frequency energy and, if not installed and used in 
accordance with the instructions, may cause harmful interference to radio 
communications. However, there is no guarantee that interference will not 
occur in a particular installation. If this equipment does cause harmful 
interference to radio or television reception, which can be determined by 
turning the equipment off and on, the user is encouraged to try to correct the 
interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to 
which the receiver is connected.

Consult your point of purchase or service representative for additional 
suggestions.

The manufacturer is not responsible for any radio or television interference 
caused by using other than recommended cables or by unauthorized changes 
or modifications to this equipment. Unauthorized changes or modifications 
could void the user's authority to operate this equipment.

Note: To assure compliance with FCC regulations on 

electromagnetic interference for a Class B computing 
device, use a properly shielded and grounded cable such 
as Lexmark part number 12A2405. Use of a substitute 
cable not properly shielded and grounded may result in a 
violation of FCC regulations.