Whirlpool mede300 사용자 설명서

■

Is the exhaust vent diameter the correct size?

Use 4" (102 mm) diameter vent material.

■

Is the dryer located in a room with temperature below 45ºF
(7ºC)?

Proper operation of dryer cycles requires temperatures above
45ºF (7ºC).

■

Is the dryer located in a closet?

Closet doors must have ventilation openings at the top and
bottom of the door. The front of the dryer requires a minimum
of 1" (25 mm) of airspace, and, for most installations, the rear
of the dryer requires 5" (127 mm). See the Installation
Instructions.

Cycle time too short

WARNING

Excessive Weight Hazard

Use two or more people to move and install dryer.

Failure to do so can result in back or other injury.

■

Is the automatic cycle ending early?

The load may not be contacting the sensor strips. Level the
dryer.

Change the dryness level setting on Automatic Cycles.
Increasing or decreasing the dryness level will change the
amount of drying time in a cycle.

Lint on load

■

Is the lint screen clogged?

Clean lint screen. Check for air movement.

Stains on load or drum

■

Was dryer fabric softener properly used?

Add dryer fabric softener sheets at the beginning of the cycle.
Fabric softener sheets added to a partially dried load can

stain your garments. Do not use fabric softener sheets with
steam cycles.

Drum stains are caused by dyes in clothing (usually blue
jeans). These will not transfer to other clothing.

Loads are wrinkled

■

Was the load removed from dryer at the end of the cycle?

Select Enhanced Touch Up Cycle to tumble the load with
water and heat. This cycle is best for smoothing out wrinkles
and reducing odors from loads consisting of wrinkle-free
cotton, cotton polyester blends, common knits, and synthetic
garments.

NOTE: Refer to garment care label instructions. Dry clean only
garments are not recommended.

■

Loads are still wrinkled following Steam Cycle?

Make sure water is connected to the dryer. Check that water
inlet hose is connected to both the faucet and dryer’s water
inlet valve. Check that the water supply is turned on.

■

Was the correct number of garments selected for the
Quick Refresh Cycle?

Check that you selected the correct Number of Garments
feature equal to the number of garments refreshed.

■

Was the dryer overloaded?

Dry smaller loads that can tumble freely. Smaller loads of
Number of Garments yield best results with Quick Refresh
Cycle. Results may also vary depending on fabric type. This
cycle is best for reducing wrinkles and odors from loads
consisting of wrinkle-free cotton, cotton polyester blends,
common knits, and synthetics.

Odors

■

Have you recently been painting, staining, or varnishing in
the area where your dryer is located?

If so, ventilate the area. When the odors or fumes are gone
from the area, rewash and dry the clothing.

■

To remove odors left in garments after wearing, select Quick
Refresh for small loads of garments. This cycle is best for
reducing wrinkles and odors from loads consisting of wrinkle-
free cotton, cotton polyester blends, common knits, and
synthetics.

■

Is water connected to the dryer?

Check that water inlet hose is connected to both the faucet

and dryer’s water inlet valve. Check that the water supply is
turned on.