3com 8807 참조 가이드

[3Com-Ethernet5/1/2] traffic-redirect inbound link-group 4000 

 

interface ethernet5/1/1 4094 l3-vpn 

# Configure traffic redirection on a service processor card for packets that match 
the permit rules in ACL 3000.

1 Redirect the packets of VLAN4 that match the permit rules in ACL 3000 to a 

service processor card in Ethernet port view.

<SW8800> system-view 

System View: return to User View with Ctrl+Z.

[SW8800]interface e thernet5/1/2

 

[3Com-Ethernet5/1/2] traffic-redirect inbound ip-group 3000 slot 2 4 

2 Redirect the packets that are distributed to the service processor card to the next 

hop 202.119.85.1 and 202.119.95.1 in VLAN view.

<SW8800> system-view

 

System View: return to User View with Ctrl+Z.

 

[SW8800] vlan 4

 

[3Com-vlan4] traffic-redirect inbound ip-group 3000 next-hop 202.119

.85.1 202.119.95.1 slot 2 

traffic-shape [ queue queue-id ] max-rate burst-size

undo traffic-shape [ queue queue-id ]

Ethernet port view, port group view

queue queue-id: Specifies queue ID, in the range of 0 to 7.

max-rate: Maximum traffic rate in Kbps of the port.

burst-size: Burst size in KB. Its value should be the integer of 4.

Use the traffic-shape command to enable traffic shaping.

Use the undo traffic-shape command to cancel traffic shaping.

The switch supports both shaping traffic based on port (shaping all traffic at the 
port) and shaping the traffic in a specified queue at the port. You can achieve the 
former mode by specifying no queue ID or the latter mode by specifying queue ID.

# Shape the traffic in the outbound queue 2 at the port: maximum rate 500 Kbps, 
burst size 12 Kbytes.

<SW8800> system-view

 

System View: return to User View with Ctrl+Z.