3com 8807 참조 가이드

C

HAPTER

 20: 802.1

X

 C

ONFIGURATION

 C

OMMANDS

System view

None

Use the dot1x dhcp-launch command to set 802.1x to disable the switch to 
trigger the user ID authentication over the users who configure static IP addresses 
in DHCP environment.

Use the undo dot1x dhcp-launch command to set 802.1x to enable the switch 
to trigger the authentication over them.

By default, the switch can trigger the user ID authentication over the users who 
configure static IP addresses in DHCP environment.

Related command: dot1x.

# Disable the switch to trigger the authentication over the users who configure 
static IP addresses in DHCP environment.

[SW8800] dot1x dhcp-launch 

dot1x guest-vlan vlan-id [ interface interface-list ]

undo dot1x guest-vlan vlan-id [ interface interface-list ]

System view, Ethernet interface view

vlan-id: ID of the VLAN specified as the Guest VLAN. It ranges from 1 to 4094.

interface-list: List of Guest VLAN-enabled ports expressed in the format 
interface-list =interface-type interface-number [ to interface-type 
interface-number ] &<1-10>. interface-type means the interface type, 
interface-number is the interface number. Refer to command parameters in the 
"Port" section in the manual for the respective meanings and value ranges of 
them. The interface number after the key word to should be no smaller than the 
interface number before to. &<1-10> in the command means that the preceding 
parameter can be entered up to 10 times.

Use the dot1x guest-vlan command to enable Guest VLAN on a specific port.

Use the undo dot1x guest-vlan command to disable Guest VLAN.

If you execute the dot1x guest-vlan command in system view and do not provide 
the interface-list argument, Guest VLAN is enabled on all ports. However, if you