3com 8807 참조 가이드

network, other interfaces will not forward the routes of the interface using this 
command and it seems that the interface disappeared.

When the network command is used on an address, the effect is that the 
interface on the network segment at this address is enabled. For example, the 
results of viewing the network 129.102.1.1 with both the display 
current-configuration command and the display rip command are shown as 
the network 129.102.0.0.

Related command: rip work.

# Enable the RIP on the interface with the network address as 129.102.0.0.

[3Com-rip] network 129.102.0.0 

peer ip-address

undo peer ip-address

RIP view

ip-address: The interface IP address of the peer router, in dotted decimal format.

Use the peer command to configure the sending destination address of the peer 
device. Use the undo peer command to cancel the set destination address.

By default, do not send RIP packet to any destination.

RIP exchanges routing information with non-broadcasting networks in unicast 
view. This command specifies the sending destination address to fit some 
non-broadcast networks. Usually, it is not recommended to use this command.

# Specify the sending destination address 202.38.165.1.

[3Com-rip] peer 202.38.165.1 

preference value

RIP view

value: Preference level, ranging from 1 to 255. By default, the value is 100.