3com 8807 참조 가이드

C

HAPTER

 26: I

NTEGRATED

 IS-IS C

ONFIGURATION

 C

OMMANDS

IS-IS view

network-entity-title: Specify the network entity title in the X...X.XXXX....XXXX.00 
format, in which the first "X...X" is the area address, the twelve Xs in the middle is 
the System ID of the router, and the 00 in the end is SEL.

Use the network-entity command to configure the name of Network Entity Title 
(NET) of the IS-IS routing process.

Use the undo network-entity command to delete a NET.

By default, no NET is defined.

NET means the Network Service Access Point (NSAP). An IS-IS NET is 8 to 20 bytes 
long.

It consists of three parts. Part one is area ID, which is variable (1 to 13 bytes), and 
the area IDs of the routers in the same area are identical. Part two is system ID (6 
bytes) of this router, which must be unique in the whole area and backbone area. 
Part three, the last byte "SEL", whose value must be "00". Usually, one router can 
be configured with one NET. When the area is redesigned by combination or 
separation, after reconfiguration, the correctness and continuity of the routes 
must be ensured.

Related command: isis, isis enable.

# Specify NET as "10.0001.1010.1020.1030.00", in which the system ID is 
"1010.1020.1030", area ID is "10.0001".

[SW8800] isis

 

[3Com-isis] network-entity 10.0001.1010.1020.1030.00 

preference value

IS-IS view

value: Specifies the preference, ranging from1 to 255. By default, the value is 15.

Use the preference command to configure the preference of IS-IS protocol.

Use the undo preference command to restore the default value.