3com 8807 참조 가이드

C

HAPTER

 34: S

TATIC

 M

ULTICAST

 MAC A

DDRESS

 C

ONFIGURATION

 C

OMMAND

The PIM protocol must not be enabled on the corresponding virtual interface of 
the specified VLAN.

Related command: display mac-address multicast static.

# Add a new multicast MAC address. The MAC address is 0100-1000-1000. Ports 
are from Ethernet 1/1/1 to Ethernet 1/1/5, and these ports belong to Vlan 2

[SW8800] mac-address multicast 0100-1000-1000 interface Ethernet 1/1

/1 to Ethernet 1/1/5 vlan 2 

display mac-address multicast static [ [ mac-addr ] vlan vlan-id ]

Any view

mac-addr: Multicast MAC address.

vlan-id: ID of the VLAN.

Use the display mac-address multicast static command to display the 
information of a static multicast group. The information includes multicast MAC 
address, VLAN ID, address status, port name, and aging time.

If all ports in the configured static multicast MAC group are out of position (the 
corresponding module has been pulled out after configuration), the port name in 
the MAC information is displayed as N/A when you use this command.

# Display all static multicast MAC address information

<SW8800> display mac-address multicast static

 

MAC ADDR        VLAN ID   STATE           PORT INDEX           AGING TIME(s)

 

0100-5e01-0101     3      Config static   Ethernet0/1/23       N/A

 

                                                  Ethernet0/1/24

 

 
  ---  1 mac address(es) found  ---                                 

Table 84   Description on the fields of display mac-address multicast static

MAC ADDR 

Multicast MAC address 

VLAN ID 

The ID of the VLAN where the MAC address is located. 

STATE 

Status of MAC address.

The status of the static multicast MAC address is always "Config static". 

PORT INDEX 

Port name.

When no valid port is in position, the port name is displayed as N/A 

 AGING TIME(s) 

Aging time.

The aging time of a static multicast MAC address is always "N/A".