3com 8807 참조 가이드

For detailed description on interface-type and interface-number see Port 
Configuration section of this manual.

vlan-id: Specifies the VLAN ID.

Use the mac-address command to add/modify the MAC address table entry.

Use the undo mac-address command to cancel the MAC address table entry

If the input address has been existed in the address table, the original entry will be 
modified. That is, replace the interface pointed by this address with the new 
interface and the entry attribute with the new attribute (dynamic entry, static entry 
and permanent entry).

All the (MAC unicast) addresses on a certain interface can be deleted. User can 
choose to delete any of the following addresses: address learned by system 
automatically, dynamic address configured by user, static and permanent 
addresses configured by user.

Related command: display mac-address.

# Configure the port number corresponding to the MAC address 00e0-fc01-0101 
as Ethernet2/1/1 in the address table, and sets this entry as static entry.

<SW8800> system-view

 

System View: return to User View with Ctrl+Z.  

 

[SW8800] mac-address static 00e0-fc01-0101 interface ethernet 2/1/1 vlan 2 

mac-address max-mac-count count

Ethernet port view

count: Maximum number of MAC addresses learned by a port, ranging from 0 to 
14,336, the value of 0 means that address learning is disabled.

Use the mac-address max-mac-count command to set the maximum number of 
MAC addresses learned by an Ethernet port.

Use the undo mac-address max-mac-count command to remove the limit on 
the maximum number of MAC addresses learned by an Ethernet port.

By default, a port can learn as many MAC addresses as on an I/O Module. You can 
change the default value by using this command: if you set the value to count, 
and when the number of MAC addresses learned by the port reaches this value,