3com 8807 참조 가이드

C

HAPTER

 36: PIM C

ONFIGURATION

 C

OMMANDS

must be 224.0.0.0, and source address has no mask), then it means only the (*, *, 
RP) item will be cleared.

If in this command, the group-address is any a group address, and source-address 
is 0 (where group address can have a mask, and source address has no mask), then 
only the (*, G) item will be cleared.

This command shall clear not only multicast route entries from PIM routing table, 
but also the corresponding route entries and forward entries in the multicast core 
routing table and MFC.

Related command: reset multicast routing-table, reset multicast 
forwarding-table and display pim routing-table.

# Clear the route entries with group address 225.5.4.3 from the PIM routing table.

<SW8800> reset pim neighbor 25.5.4.3 

source-policy acl-number

PIM view

acl-number: Basic or advanced ACL, in the range of 2000 to 3999.

Use the source-policy command to set the router to filter the multicast data 
packets based on source (or group) address.

Use the undo static-rp command to remove the configuration.

If resource address filtering is configured, as well as basic ACLs, then the router 
filters the resource addresses of all multicast data packets received. Those not 
matched will be discarded.

If resource address filtering is configured, as well as advanced ACLs, then the 
router filters the resource and group addresses of all multicast data packets 
received. Those not matched will be discarded.

When this feature is configured, the router filters not only multicast data, but the 
multicast data encapsulated in the registration packets.

The new configuration overwrites the old one if you run the command for a 
second time.

# Set to receive the multicast data packets from source address 10.10.1.2, but 
discard those from 10.10.1.1.