3com 8807 참조 가이드
42
VPLS C
ONFIGURATION
C
OMMANDS
n
The VPLS commands require the 3C17548 VPLS Application Module.
VPLS Configuration
Commands
Commands
bandwidth
Syntax
bandwidth bw-limit
View
VSI view
Parameter
bw-limit: Limit on Virtual Switching Instance (VSI) rate, which is in kbit/s. The
system automatically takes the smallest number that can be exactly divided by 64.
By default, VSI rate is limited at 102,400 kbit/s..
system automatically takes the smallest number that can be exactly divided by 64.
By default, VSI rate is limited at 102,400 kbit/s..
Description
Use the bandwidth command to configure a limit on VSI bandwidth.
Note that the rate actually supported ranges from 64 kbps to 2,097,152 kbps. If
the rate you set is above 2,097,152 kbps, no rate limitation is performed, and the
part of traffic that is under the VSI and exceeding this bandwidth restriction is
discarded by the system.
the rate you set is above 2,097,152 kbps, no rate limitation is performed, and the
part of traffic that is under the VSI and exceeding this bandwidth restriction is
discarded by the system.
Example
# Configure the bandwidth of VSI 3Com as 20 Mbps.
<SW8800> system-view
[SW8800] vsi 3Com static
[3Com-vsi-3Com] bandwidth 20480
broadcast-restrain
Syntax
broadcast-restrain percent
View
VSI view
Parameter
percent: Percentage of VSI broadcast suppression. It ranges from 1 to 100 and
defaults to 5, which means the percentage is 5%.
defaults to 5, which means the percentage is 5%.