3com 8807 사용자 가이드
300
C
HAPTER
30: RIP C
ONFIGURATION
Before configuring MD5 authentication, you must configure MD5 type. The usual
packet format follows RFC1723 and the nonstandard follows RFC2082.
packet format follows RFC1723 and the nonstandard follows RFC2082.
Displaying and
Debugging RIP
Debugging RIP
After the above configuration, execute the display command in any view to
display the running of the RIP configuration, and to verify the effect of the
configuration. Execute the debugging command in user view to debug the RIP
module. Execute the reset command in RIP view to reset the system configuration
parameters of RIP.
display the running of the RIP configuration, and to verify the effect of the
configuration. Execute the debugging command in user view to debug the RIP
module. Execute the reset command in RIP view to reset the system configuration
parameters of RIP.
Typical RIP
Configuration
Example
Configuration
Example
Network requirements
As shown in Figure 72, the Switch 8800 Family series routing switch C connects to
the subnet 117.102.0.0 through the Ethernet port. The Ethernet ports of the
Switch 8800 Family series routing switches A and Switch B are respectively
connected to the network 155.10.1.0 and 196.38.165.0. Switch C, Switch A and
Switch B are connected via Ethernet 110.11.2.0. Correctly configure RIP to ensure
that Switch C, Switch A and Switch B can interconnect with each other.
the subnet 117.102.0.0 through the Ethernet port. The Ethernet ports of the
Switch 8800 Family series routing switches A and Switch B are respectively
connected to the network 155.10.1.0 and 196.38.165.0. Switch C, Switch A and
Switch B are connected via Ethernet 110.11.2.0. Correctly configure RIP to ensure
that Switch C, Switch A and Switch B can interconnect with each other.
Disable RIP-2 packet authentication
undo rip authentication-mode
Table 268 Set RIP-2 packet authentication
Operation Command
Table 269 Display and debug RIP
Operation
Command
Display the current RIP running state and configuration
information.
information.
display rip
Enable the RIP packet debugging information
debugging rip packet
Disable the RIP packet debugging information
undo debugging rip packet
Enable the debugging of RIP receiving packets
debugging rip receive
Disable the debugging of RIP receiving packets
undo debugging rip receive
Enable the debugging of RIP sending packet
debugging rip send
Disable the debugging of RIP sending packet
undo debugging rip send
Reset the system configuration parameters of RIP
reset