KitchenAid 30" Range Hood with the FIT System 사용 및 관리

These range hoods are factory set for non-vented 

(recirculating) installations and come with a charcoal filter. 

See the “Assistance or Service” section for information 

on ordering a charcoal filter kit, Part Number W10355450.

Observe all governing codes and ordinances.
Ensure that the electrical installation is adequate and in 

conformance with National Electrical Code, ANSI/NFPA 

70 (latest edition) or CSA Standards C22.1-94, Canadian 

Electrical Code, Part 1 and C22.2 No. 0-M91 (latest edition), 

and all local codes and ordinances.
If codes permit and a separate ground wire is used, it is 

recommended that a qualified electrician determine that 

the ground path is adequate.
A copy of the above code standards can be obtained from:

National Fire Protection Association 

1 Batterymarch Park 

Quincy, MA 02169-7471

CSA International 

8501 East Pleasant Valley Road 

Cleveland, OH 44131-5575

 

■

A 120 volt, 60 Hz., AC only, 15-amp, fused 

electrical circuit is required.

 

■

If the house has aluminum wiring, follow 

the procedure below:
1.  Connect a section of solid copper wire 

to the pigtail leads.

2.  Connect the aluminum wiring to the added section 

of copper wire using special connectors and/or tools 

designed and UL listed for joining copper to aluminum.

Follow the electrical connector manufacturer’s recommended 

procedure. Aluminum/copper connection must conform 

with local codes and industry accepted wiring practices.

 

■

Wire sizes and connections must conform with the rating 

of the appliance as specified on the model/serial/rating 

plate. The model/serial/rating plate is located inside the 

range hood on the left wall.

 

■

Wire sizes must conform to the requirements of the National 

Electrical Code, ANSI/NFPA 70 (latest edition) or CSA 

Standards C22. 1-94, Canadian Electrical Code, Part 1 

and C22.2 No. 0-M91 (latest edition), and all local codes 

and ordinances.