KitchenAid 30" Range Hood with the FIT System 사용 및 관리

The range hood is designed to remove smoke, cooking 

vapors, and odors from the cooktop area. For best results, 

start the hood before cooking and allow it to operate several 

minutes after the cooking is complete to clear all smoke and 

odors from the kitchen.
The hood controls are located on the front panel of 

the range hood.

Press the light switch to the left to turn the light On.
Press the light switch to the right to turn the light Off.

The fan has 2 speeds.
Press the fan switch to the left for Low speed.
Press the fan switch to the right for High speed.
Return the fan switch to the center to turn the fan Off.

IMPORTANT: Clean the hood and grease filters frequently 

according to the following instructions. Replace the grease 

filter before operating hood.

IMPORTANT: Do not use soap-filled scouring pads, 

abrasive cleaners, cooktop polishing creme, steel wool, 

gritty washcloths, or paper towels.
To avoid damage to the stainless steel, do not use cleaners 

that contain chlorine.

 

■

Liquid detergent or all-purpose cleaner: 

Rinse with clean water and dry with a soft, lint-free cloth.

 

■

Glass cleaner to remove fingerprints.

 

■

For stainless steel models, rub in the direction of the 

grain to avoid scratching or damaging the surface.

 

■

For stainless steel models, use Stainless Steel Cleaner 

and Polish, Part Number 31462A (not included):  

See the “Assistance or Service” section to order.

To Remove the Filter:
1.  Remove the screw from the grease filter retainer.
2.  Turn the grease filter retainer to release the filter.

3.  For non-vented (recirculating) installations: The charcoal 

filter is not washable. It should last up to 6 months with 

normal use. For information on ordering, see the “Assistance 

or Service” section. Dispose of the old charcoal filter.

To Replace the Filter:
1.  To reinstall the filter, place the back edge of the filter into the 

channel at the rear of the hood. Push the filter into place and 

turn the filter retainer to secure the filter to the range hood.

2.  Replace the screw in the grease filter retainer.

Turn off the range hood and allow the light bulb to cool.
1.  Disconnect power.
2.  Squeeze the plastic lens cover and remove it from the hood.

3.  Screw a 120V, 75W maximum, light bulb with 

E26 base into the socket.

4.  Replace the lens cover by squeezing the cover 

and inserting the tabs into the slots.

5.  Reconnect power.
If the new light does not operate, make sure the light bulb 

is inserted correctly before calling service.