KitchenAid 30" Range Hood with the FIT System 설치 가이드

Gather the required tools and parts before starting 

installation. Read and follow the instructions provided 

with any tools listed here.

Remove parts from package. Check that all parts are included.

 * For information on ordering, see the “Assistance or Service” 

section.

IMPORTANT: Observe all governing codes and ordinances.

 

■

It is the installer’s responsibility to comply with installation 

clearances specified on the model/serial/rating plate. 

The model/serial/rating plate is located inside the range 

hood on the left wall.

 

■

Range hood location should be away from strong draft 

areas, such as windows, doors, and strong heating vents.

 

■

Cabinet opening dimensions that are shown must be 

used. Given dimensions provide minimum clearance. 

Consult the cooktop/range manufacturer installation 

instructions before making any cutouts.

 

■

This range hood is recommended for use with cooktops 

with a maximum total rating of 40,000 BTUs or less.

 

■

Grounded electrical outlet is required. See “Electrical 

Requirements” section.

 

■

All openings in ceiling and wall where range hood will 

be installed must be sealed.

 

■

These range hoods are factory set for vented installations. 

Models that are capable of being installed as non-vented 

(recirculating) require charcoal filters. See the “Assistance or 

Service” section for information on ordering charcoal filters.

The installation of this range hood must conform to the 

Manufactured Home Construction Safety Standards, Title 

24 CFR, Part 328 (formerly the Federal Standard for Mobile 

Home Construction and Safety, title 24, HUD, Part 280), 

or when such standard is not applicable, the standard for 

Manufactured Home Installation 1982 (Manufactured Home 

Sites, Communities and Setups) ANSI A225.1/NFPA 501A 

or latest edition, or with local codes.

Caulking gun and weatherproof
caulking compound

Jigsaw or keyhole saw

Flat-blade
screwdriver

Drill with ¹⁄₈" 
(3 mm), ¹⁄₂" 
(13 mm)
and 1¹⁄₄" 
(3 cm) bits

Wire stripper

#2 Phillips
screwdriver

Metal snips

Pencil

3¹⁄₄" x 10" (8.3 x 25.4 cm)
rectangular damper

#8-18 x ⁵⁄₈" 
(4.2 x 16 mm)
truss-head screws

#8-18 x 1"
(4.2 x 25 mm) 
flat-head screws

Drywall
anchors

Mounting
brackets

UL Listed/CSA 
Approved 
wire connectors

UL Listed/CSA 
Approved ¹⁄₂" (13 mm) 
strain relief

120V, 75W 
maximum, 
type E26 
incandescent lamp

3¹⁄₄" x 10" 
(8.3 x 25.4 cm) rectangular 
metal vent system with
wall or roof cap

Duct tape

Power 
cord kit 
Part Number
W10355452*

Stainless steel cleaner 
and polish 
Part Number 31462A*