KitchenAid 30" Range Hood with the FIT System 설치 가이드

 

■

Depending on your model, determine which venting 

method to use: roof or wall.

 

■

It is recommended that the vent system be installed before 

the range hood is installed. Go to “Venting System” in the 

“Installation Requirements” section if you need assistance.

 

■

Before making cutouts, make sure there is proper clearance 

within the ceiling or wall for the vent system.

1.  Disconnect Power

2.  Mark Hole Locations

Align the exterior edge of the mounting brackets 

with the exterior edges of the upper cabinet.
IMPORTANT: The brackets should touch the upper cabinet.
With a pencil, mark the upper holes on the brackets.

3.  Install Brackets

 

■

Using a #2 Phillips screwdriver, install the drywall anchors.

 

■

Using #8-18 x 1" (4.2 x 25 mm) flat-head #2 Phillips screws, 

install the mounting brackets using the upper holes.

NOTE: For installations to a surface other than drywall, 

it is recommended that a qualified contractor determine 

the anchoring method.

4.  Prepare Range Hood

 

■

Set the range hood on its back on a covered surface.

 

■

Using a #2 Phillips screwdriver, remove the rectangular 

damper attached with 3.5 x 9.5 mm screws.

 

■

Using a #2 Phillips screwdriver, remove the electrical 

box cover.

 

■

Using a flat-blade screwdriver, remove the appropriate 

power supply knockout.